About us | Feedback | Contact us
New hot products | Clearance items

Acura
Alfa Romeo
Audi
BMW
Cadillac
Chery
Chevrolet
Chrysler
Citroen
Daewoo
Dacia
Daihatsu
Dodge
Fiat
Ford
Honda
Hummer
Hyundai
Infiniti
Isuzu
Jaguar
Jeep
Kia
Lada
Lancia
Land Rover
Lexus
Lincoln
Mazda
Mercedes
Mercury
Metro
Mini
Mitsubishi
Nissan
Opel/Vauxhall
Peugeot
Pontiac
Porsche
Proton
Renault
Rover
Saab
Ssangyong
Seat
Skoda
Smart
Subaru
Suzuki
Taxi
Toyota
Volkswagen
Volvo

How to install

Dash kits - Installation Instructions

Before you begin the installation process, check to make certain that the kit you have received is the correct kit for your vehicle. Attached to the outside of the carton you will find a complete diagram for this kit.
For the best results, the temperature of the dash and the dash pieces should be approximately 70F (21C). In colder conditions this may be achieved through the use of a heat gun or hair dryer.

Step 1: CLEAN THE SURFACE

THE SURFACE MUST BE PERFECTLY DRY, AND FREE OF ANY OILS OR CONTAMINANTS for the dash kit to adhere properly!
Use the alcohol pads included in this kit to wipe all surfaces clean. In many cases the surface may require additional cleaning.

 


 

 

 

Step 2: REMOVE THE INDIVIDUAL PIECE

Identify the location on the dash where each piece in the kit is to be applied. In preparation for the installation of each piece, simply lift it off the packing board. Caution: To insure the strongest adhesion, AVOID MAKING DIRECT CONTACT WITH THE ADHESIVE SURFACE.

 


 

 

 

Step 3: INSTALL THE KIT

Starting with any of the larger pieces and beginning from any edge, apply the piece onto the dash. DO NOT PRESS FIRMLY INTO PLACE AT THIS TIME.
If the piece is not positioned properly, simply lift it up and reinstall to achieve the desired fit.

 


 

 

 

Step 4: COMPLETE THE INSTALLATION

To complete installation, firmly press each piece into position while gently warming with a heat gun or hair dryer. DO NOT OVERHEAT!
Installation is now complete. Your B&I dash kit will provide you with many years of product satisfaction while it increases the value of your vehicle. Thank you for your confidence in B&I Trim Products. 

 

Deflectors - Installation Instructions

1.

2.

3.

4.

 

 

 

 

 

5.

6.

7.

8.

  1. Clean inside of channel using a paper towel and alcohol
  2. Remove the protective backing from one part at a time
  3. Insert front edge of deflector
  4. Insert rear edge leaving a gap at the top (1.5 cm)
  5. Bow the deflector outward
  6. Pull down and tuck in working from front to rear
  7. To complete installation, pull window carefully up and leave at close position at least 1 hour
Shopping cart :
Price:0.00
Quantity:0 pcs.
 
Sign-in :
Search product :
MORE INFORMATION :
2006 J&J AUTOMOTIVE | Generated by CMS WEBMagic & e-shop SHOPMagic | Design & implementation by